View Single Post
  #3  
Old 11-20-2009, 09:59 PM
ACE ACE is offline
Pat (MN)
 
Join Date: Nov 2009
Location: Belle Plaine MN
Posts: 41
as far as the fuel controller and a power commander are concerned they are in essence two different animals. a power commander is a fine tune tool used for VERY specific programming. that being said it requires a dyno to get it dialled in correctly. a fuel programer is a mapping tool. it has preset maps in which you plug in what you have and it has that map, no dyno needed. BUT a power commander is for serious motorwork I.E. if your going to be boring and adding over sized pistons etc. etc. basically if your not try ing to build a 10 second bike, i'd go fuel programmer. hope this helps.- ACE
Reply With Quote